Toyota Tundra Service Manual: Cursor or Map Rotates when Vehicle Stopped

PROCEDURE

1.

CHECK CONDITION

(a) Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.

HINT:

If the vehicle is turned on a turntable with the ignition switch to ON, the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the ignition switch off and back to ON again with the vehicle completely stopped.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN IGNITION SWITCH TO ON WHEN VEHICLE IS COMPLETELY STOPPED

    Confirm Vehicle Headunit Functionality

    Data List / Active Test

    See More:

    Toyota Tundra Service Manual > Front Crankshaft Oil Seal: Installation
    INSTALLATION PROCEDURE 1. INSTALL FRONT CRANKSHAFT OIL SEAL (a) Apply MP grease to the lip of a new oil seal. (b) Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge. SST: 09223-22010 SST: 09506-35010 NOTICE: Keep the lip free ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0098