Toyota Tundra Service Manual: Vehicle Speed Sensor (C1A45)

DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC Code	DTC Detection Condition	Trouble Area
C1A45	A fail flag is transmitted from the skid control ECU (brake actuator assembly).	Vehicle stability control system Blind spot monitor sensor LH Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.	CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for vehicle stability control system DTCs (See page ).

OK:

Vehicle stability control system DTCs are not output.

GO TO VEHICLE STABILITY CONTROL SYSTEM

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check if the same DTC is output again (See page ).

Result

Result	Proceed to
No DTC is output	A
DTC C1A45 is output ("Blind Spot Monitor Master")	B
DTC C1A45 is output ("Blind Spot Monitor Slave")	C

USE SIMULATION METHOD TO CHECK

REPLACE BLIND SPOT MONITOR SENSOR RH

REPLACE BLIND SPOT MONITOR SENSOR LH

Toyota Tundra Service Manual > Air Conditioning System(for Automatic Air Conditioning System): Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)
DESCRIPTION The No. 1 damper servo sub-assembly (air mix damper servo motor [for driver side]) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper (fo ...

Toyota Tundra Owners Manual