DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT:
CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Check the condition of the rear bumper around the blind spot monitor sensors. HINT: When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.
(a) Clean the rear bumper. (b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Click here NOTICE: Before replacing the blind spot monitor sensor LH, visually check for damage to the stud bolts or area surrounding the blind spot monitor sensor LH. If there is any damage to the stud bolts or area surrounding the blind spot monitor sensor LH, perform Blind Spot Monitor Sensor Installation Condition Inspection and adjust according to the result.
(a) Check the installation condition of the blind spot monitor sensor LH. Click here OK: The blind spot monitor installation position is within the specified range
(a) Adjust the installation position of the blind spot monitor sensor LH. Click here
(a) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Click here
|
Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: Lost Communication with ECM / PCM "A" (U0100,U0104,U0122,U0125,U0126,U0129,U0137)
DESCRIPTION The millimeter wave radar sensor assembly and ECM communicate with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area U ...