Toyota Tundra Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and reading various data output from the vehicle's trailer brake control ECU (brake control with bracket relay).

The trailer brake control ECU (brake control with bracket relay) records DTCs when it detects a malfunction in itself or in its circuits.

To check the DTCs, connect the Techstream to the DLC3 on the vehicle. The Techstream enables you to clear the DTCs, activate the various actuators, and check the Data List.

(a) Check the battery voltage.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge the battery before proceeding to the next step.

(b) Check the DLC3 (See page ).

2. DIAGNOSIS

(a) When a malfunction occurs in the trailer brake control system, a warning is displayed on the multi-information display.

    Data List / Active Test

    Diagnostic Trouble Code Chart

    See More:

    Toyota Tundra Service Manual > Power Steering System(for 3ur-fe, 3ur-fbe): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DRIVE BELT (a) Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. HINT: Cracks on the rib side of a belt are considered acceptable. Replace the belt if there are any missing ribs. (b) Check by hand ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0108