Toyota Tundra Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

DTC CHECK/CLEAR

(a) Check for DTCs.

(1) Turn the ignition switch off.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to ON.

(4) Turn the Techstream on.

(5) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

(6) Check the details of the DTCs.

Click here

(b) Clear the DTCs.

(1) Turn the ignition switch off.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to ON.

(4) Turn the Techstream on.

(5) Operate the Techstream to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

(6) Press the DTC clear button.

    Diagnostic Trouble Code Chart

    Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)

    See More:

    Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Terminals Of Ecu
    TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the J26 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Tester Connection ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0164