REMOVAL PROCEDURE 1. REMOVE INSTRUMENT SIDE PANEL LH 2. REMOVE FRONT DOOR SCUFF PLATE LH (a) for Double Cab: (See page (b) for CrewMax: (See page
3. REMOVE COWL SIDE TRIM BOARD LH 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 5. REMOVE NO. 2 SWITCH HOLE BASE 6. REMOVE VSC OFF SWITCH (a) Disconnect the VSC OFF switch connector.
|
Toyota Tundra Service Manual > Headlight Assembly(for Led Headlight): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY LH (a) Connect each connector and a ...
