Toyota Tundra Service Manual: Disassembly

Toyota Tundra Service Manual / Brake / Brake / Rear Brake / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

2. REMOVE REAR DISC BRAKE BLEEDER PLUG

3. REMOVE CYLINDER BOOT

(a) Using a screwdriver, remove the cylinder boot from the cylinder.

HINT:

Tape the screwdriver tip before use.

4. REMOVE REAR DISC BRAKE PISTON

(a) Place a piece of cloth or a similar object between the piston and cylinder.

(b) Use compressed air to remove the piston from the cylinder.

CAUTION:

Do not place your fingers in front of the piston when using compressed air.

5. REMOVE PISTON SEAL

(a) Using a screwdriver, remove the piston seal from the cylinder.

NOTICE:

Do not damage the inner cylinder or cylinder groove.

HINT:

Tape the screwdriver tip before use.
    Components

    Inspection

    See More:

    Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Dtc Check / Clear
    DTC CHECK / CLEAR CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes. (e) Check for DTCs. CHECK FOR ECM DTC (a) Connect the Tec ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.033