Toyota Tundra Service Manual: Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL LH

2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

(a) Remove the 2 bolts and disconnect the rear disc brake cylinder. NOTICE: Do not disconnect the flexible hose from the disc brake cylinder. Do not twist or bend the flexible hose.

(b) Hang the disc brake cylinder with a piece of wire.

3. REMOVE REAR DISC

4. REMOVE PARKING BRAKE SHOE RETURN SPRING

(a) Using SST, remove the return spring. SST: 09703-30011

5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

(a) Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin. SST: 09718-00011

(b) Disconnect the tension spring.

(c) Remove the No. 1 parking brake shoe and shoe adjuster screw set.

6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

(a) Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin. SST: 09718-00011

(b) Remove the No. 2 parking brake shoe.

7. REMOVE PARKING BRAKE SHOE LEVER LH

(a) Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

(b) Remove the parking brake shoe lever.

8. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Disconnect the bolt and No. 3 parking brake cable.

9. REMOVE PARKING BRAKE ANCHOR BLOCK

(a) Remove the 2 nuts and anchor block.