REPAIR PROCEDURE 1. REPAIR INTAKE VALVE SEAT
NOTICE:
- Repair the seat while checking the seating position.
- Keep the lip free of foreign matter.
- Take off a cutter gradually to make the intake valve seat smooth.
| (a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification. |
|
| (b)
Using 30° and 60° cutters, correct the valve seat so that the valve
contacts the entire circumference of the seat. The contact should be in
the center of the valve seat, and the valve seat width should be
maintained within the specified range around the entire circumference of
the seat. Standard width: 1.1 to 1.5 mm (0.0433 to 0.0591 in.) |
|
(c) Hand-lap the valve and valve seat with an abrasive compound. (d) Check the valve seating position.
2. REPAIR EXHAUST VALVE SEAT
NOTICE:
- Repair the seat while checking the seating position.
- Keep the lip free of foreign matter.
- Take off a cutter gradually to make the exhaust valve seat smooth.
| (a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification. |
|
| (b)
Using 30° and 60° cutters, correct the valve seat so that the valve
contacts the entire circumference of the seat. The contact should be in
the center of the valve seat, and the valve seat width should be
maintained within the specified range around the entire circumference of
the seat. Standard width: 1.1 to 1.5 mm (0.0433 to 0.0591 in.) |
|
(c) Hand-lap the valve and valve seat with an abrasive compound. (d) Check the valve seating position. |
