DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(c) Pull the magnet starter switch and while lifting the front part of the magnet starter switch, release the plunger hook from the drive lever and remove the magnet starter switch. 2. REMOVE STARTER YOKE ASSEMBLY
(b) Pull out the starter yoke together with the starter commutator end frame.
3. REMOVE STARTER BRUSH HOLDER ASSEMBLY
(b) Remove the starter brush holder. 4. REMOVE STARTER ARMATURE ASSEMBLY
5. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(d) Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch. |
Toyota Tundra Service Manual > Headlight Assembly(for Led Headlight): Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. It is possible that a headlight assembly is incorrectly installed, affecting headlight aim. Headlight assembly installation should be considered prior to performing ...