Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Starting / Starter(for 2.0 Kw Type) / Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(See page )

4. REMOVE STARTER COVER

(a) Remove the 3 bolts and starter cover.

5. REMOVE STARTER ASSEMBLY

(a) Detach the 2 wire harness clamps.

(b) Disconnect the starter connector.

(c) Remove the nut and disconnect the starter wire.

(d) Remove the 2 bolts and starter.

(e) Remove the flywheel housing side cover.
    Reassembly

    Starting System

    See More:

    Toyota Tundra Service Manual > Air Conditioning System(for Automatic Air Conditioning System): ECU Power Source Circuit
    DESCRIPTION This circuit provides power to operate the air conditioning amplifier. WIRING DIAGRAM PROCEDURE 1. INSPECT FUSE (ECU-B NO.2) (a) Remove the ECU-B NO.2 fuse from the driver side junction block. (b) Measure the resistance according to the value(s) in the table below. Standard resistance: T ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0342