ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY  (a) Loosen the bolt of the park/neutral position switch and move the shift lever to N. (b) Align the groove with the neutral basic line. (c) Hold the switch in position and tighten the bolt. Torque: 13 N·m {130 kgf·cm, 9 ft·lbf} (d) After the adjustment, perform the on-vehicle inspection (See page
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE 1. PRE-INSPECTION (a) Brake pedal inspection (1) Perform a visual inspection and operate the brake pedal ...
).
