INSTALLATION PROCEDURE 1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY) (a) Connect the 2 connectors to the trailer brake control ECU (brake control with bracket relay). (b) install the trailer brake control ECU (brake control with bracket relay) with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} 2. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 3. INSTALL LOWER INSTRUMENT PANEL Click here 4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 5. INSTALL INSTRUMENT SIDE PANEL RH Click here 6. INSTALL COWL SIDE TRIM BOARD RH Click here 7. INSTALL FRONT DOOR SCUFF PLATE RH Click here
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 9. PERFORM DIAGNOSTIC SYSTEM CHECK Click here 10. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Service Manual > Sfi System: Basic Inspection
CAUTION / NOTICE / HINT When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can ...
