INSTALLATION PROCEDURE 1. INSTALL COLUMN SHIFT ASSEMBLY (a) Using a T30 "TORX" wrench, install the column shift with the 3 bolts. Torque: 4.0 N·m {41 kgf·cm, 35 in·lbf} (b) Connect the connector and attach the harness clamp.
2. ADJUST SHIFT LEVER POSITION 3. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY (See page
4. INSPECT SHIFT LEVER POSITION |
Toyota Tundra Service Manual > Fuel Pump: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE ASSEMBLY 2. REMOVE SUB TANK (a) Disconnect the fuel pump connector. (b) Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps. (c) Disconnect the fuel tube. (d) Using a screwdriver ...