ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SHIFT LEVER POSITION (a) When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position. (b) Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R. If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition. |
Toyota Tundra Service Manual > Side Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE LOWER NO. 1 SIDE PANEL MOULDING LH HINT: When removing the lower No. 1 side panel moulding LH, heat the vehicle body and lower No. 1 side panel m ...
