Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Transmission Wire / Inspection

INSPECTION

PROCEDURE

1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)

(a) Measure the resistance according to the value(s) in the table below.

HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

Standard Resistance:

Tester Connection	ATF Temperature	Specified Condition
2 (OT-) - 13 (OT+)	10°C (50°F)	5 to 8 kΩ
2 (OT-) - 13 (OT+)	25°C (77°F)	2.5 to 4.5 kΩ
2 (OT-) - 13 (OT+)	110°C (230°F)	0.22 to 0.28 kΩ
3 (OT2-) - 14 (OT2+)	10°C (50°F)	5 to 8 kΩ
3 (OT2-) - 14 (OT2+)	25°C (77°F)	2.5 to 4.5 kΩ
3 (OT2-) - 14 (OT2+)	110°C (230°F)	0.22 to 0.28 kΩ

If the result is not as specified, replace the transmission wire.

See More:

Toyota Tundra Service Manual > Outer Rear View Mirror: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL OUTER MIRROR COVER LH (for Extended Type) (a) Attach the 2 claws to install the outer mirror cover LH. 2. INSTALL SIDE TURN SIGNAL LIGHT LENS ...

Toyota Tundra Service Manual: Inspection

Components

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual