Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / Axle / Rear Axle Shaft / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR AXLE SHAFT

(a) Using a dial indicator, measure the rear axle shaft runout and flange runout.

Maximum runout:

Shaft runout

1.50 mm (0.0591 in.)

Flange runout

0.05 mm (0.00197 in.)

If the rear axle shaft or flange is damaged or worn, or if the runout is greater than the maximum, replace the rear axle shaft.
    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Transfer Assembly: Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Coat all of the sliding and rotating surfaces with Toyota Genuine Transfer gear oil LF 75W or equivalent before reassembly. PROCEDURE 1. INSTALL TRANSFER CASE OIL SEAL (a) Using SST and a hammer, tap in a new transfer case oil seal as shown in the illustratio ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0129