Toyota Tundra Service Manual: Customize Parameters

Toyota Tundra Service Manual / Engine, Hybrid System / Cruise Control / Lane Departure Alert System / Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE LANE DEPARTURE ALERT SYSTEM

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

(a) Customizing with the Multi-information display

(1) Turn the ignition switch to ON.

(2) Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup

(3) Select the setting by referring to the table below.

(4) Change the settings of the lane departure alert using the steering pad switch assembly.

Lane Departure Alert

Item

Content

Setting

Default

LDA Sensitivity

Timing of lane departure warning
  • High (graphic display)
  • Standard (graphic display)

Standard

Sway Warning

Vehicle sway warning function

ON/OFF

ON

Sway Warning Sensitivity

Vehicle sway detection sensitivity
  • High (graphic display)
  • Standard (graphic display)
  • Low (graphic display)

Standard
    FCM Destination Information Uninitialized (C1AAA)

    Data List / Active Test

    See More:

    Toyota Tundra Service Manual > Steering Pad: Installation
    INSTALLATION PROCEDURE 1. INSTALL STEERING PAD (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0134