REMOVAL PROCEDURE 1. REMOVE FRONT WHEELS 2. REMOVE NO. 1 ENGINE UNDER COVER 3. DRAIN DIFFERENTIAL OIL
4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (See page 5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (See page 6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH HINT: Use the same procedure as the LH side. 7. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY
(b) Disconnect the differential actuator hose. (c) Disconnect the differential actuator connector. (d) Support the front differential with a jack. (e) Remove the A, B, C, D and E bolts. (f) Slowly lower the jack, and remove the front differential carrier. (g) Remove the F and G bolts, and differential support. |
Toyota Tundra Service Manual > Can Communication System: Check Bus 2 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and termin ...