Components COMPONENTS ILLUSTRATION  Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified. PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (a) Remove the front drive shaft (see page 3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  (a) Using SST, tap out the 2 oil seals. SST: 09308-10010 4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  (a) Apply MP grease to 2 new oil seals. (b) Using SST and a hammer, tap in the 2 oil seals. SST: 09550-00032 SST: 09950-70010 09951-07100 NOTICE: Make sure the LH and RH oil seals are installed in the proper locations. Standard oil seal depth:
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Install the front drive shaft (see page
6. ADD DIFFERENTIAL OIL
|
Toyota Tundra Service Manual > Navigation System: Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Check for DTCs, and then write them down. (f) Check ...
