Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / Propeller Shaft / Propeller Shaft Assembly(for 4wd) / Removal

REMOVAL

PROCEDURE

1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(a) Place matchmarks on the propeller shaft flange and differential flange.

Text in Illustration

*a

for Differential Side

*b

Matchmark

(b) Remove the 4 bolts and 4 nuts.

(c) w/o Bearing Washer:

(1) Remove the 2 mounting bolts from the frame crossmember.

(d) w/ Bearing Washer:

(1) Remove the 2 mounting bolts and 2 bearing washers from the frame crossmember.

(e) Place matchmarks on the propeller shaft flange and transfer flange.

Text in Illustration

*a

for Transfer Side

*b

Matchmark

(f) Remove the 4 nuts and propeller shaft.

    Reassembly

    Propeller Shaft System

    See More:

    Toyota Tundra Service Manual > Power Window Regulator Motor(for Front Door): Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0291