DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUSPENSION UPPER ARM BUSH (a) Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustration.
2. REMOVE FRONT UPPER BALL JOINT DUST COVER LH (a) Using a snap ring expander, remove the dust cover set ring. |
Toyota Tundra Service Manual > Rear Door Lock(for Double Cab): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH 2. I ...