Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT TIRE

(a) Check the tires for wear and proper inflation pressure.

Standard cold tire inflation pressure:

Tire size

Front

kPa (kgf/cm2, psi)

Rear

kPa (kgf/cm2, psi)

P255/70R18

210 (2.1, 30)

230 (2.3, 33)

P275/65R18

P275/55R20

P255/70R18 (Spare Tire)

P275/65R18 (Spare Tire)

230 (2.3, 33)

(b) Using a dial indicator, check the tire runout.

Tire runout:

3.0 mm (0.118 in.) or less

2. ROTATE TIRE

(a) Rotate the tires as shown in the illustration.

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

Text in Illustration

*a

Front of the Vehicle

3. INSPECT WHEEL BALANCE

(a) for Steel Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less

NOTICE:

  • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be attached.
  • Do not touch the adhesive surface of the tape.
  • Attach a sticking-type balance weight to the flat surface (A) shown in the illustration.

    Width (A):

    25 mm (0.984 in.)

  • Push the balance weight firmly so that it securely adheres to the position.
  • Do not reuse the balance weight.

HINT:

  • For chrome type wheels, the inner side balance weight should be installed by clipping it to the rim.
  • If necessary, check and adjust the on-the-car balance.

(b) for Aluminum Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less

NOTICE:

  • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
  • Do not touch the sticking surface of the tape.
  • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

    Width (A):

    25 mm (0.984 in.)

  • Push the balance weight firmly to adhere it to the position.
  • Do not reuse the balance weight.

HINT:

If necessary, check and adjust the on-the-car balance.

4. INSPECT FRONT AXLE HUB

(See page )

5. INSPECT REAR AXLE SHAFT

(See page )

    How To Proceed With Troubleshooting

    Precaution

    See More:

    Toyota Tundra Owners Manual > Do-it-yourself maintenance: Tire inflation pressure
    Tire inflation pressure The recommended cold tire inflation pressure and tire size are displayed on the tire and loading information label. Inspection and adjustment procedure Tire valve Tire pressure gauge 1. Remove the tire valve cap. 2. Press the tip of the tire pressure gauge onto the tire valve ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0101