Toyota Tundra Service Manual: Data List / Active Test

Toyota Tundra Service Manual / Power Source, Network / Multiplex Communication / Lin Communication System / Data List / Active Test

DATA LIST / ACTIVE TEST

1. READ DATA LIST

HINT:

Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) According to the display on the Techstream, read the Data List.

Main Body

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Communication D-Door Motor	Connection status between power window regulator motor (for driver side) and main body ECU / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
Communication P-Door Motor	Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
Communication Slide Roof	Connection status between sliding roof ECU and main body ECU / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
Communication Master SW	Connection status between power window ECU (master switch) and main body ECU / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
Number of DTC	Number of trouble codes / Min.: 0, Max.: 255	Number of DTCs	-

LIN Communication Bus Malfunction (B2325)

Diagnostic Trouble Code Chart

See More:

Toyota Tundra Service Manual > Blind Spot Monitor System: Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH. DTC No. DTC Detection Condition Trouble Area C1AB0 Both of the following conditions are met: The blind spot monitor system is on The blind spot monitor sensor is not ...

Toyota Tundra Service Manual: Data List / Active Test

LIN Communication Bus Malfunction (B2325)

Diagnostic Trouble Code Chart

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual