DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air conditioner / Trouble Codes. (e) Check for DTCs. 2. CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air conditioner / Trouble Codes. (e) Clear the DTCs. |
Toyota Tundra Service Manual > Side Moulding: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL REAR BODY NO. 3 PROTECTOR LH HINT: When installing the rear body No. 3 protector LH, heat the vehicle body and rear body No. 3 protector LH ...
