Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

6. INSTALL FRONT DOOR SERVICE HOLE COVER LH

7. INSTALL FRONT NO. 1 DOOR TRIM BRACKET

8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

9. INSTALL FRONT DOOR ARMREST COVER LH

10. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

11. INSTALL FRONT UPPER ARMREST BASE PANEL LH

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Inspection

    Removal

    See More:

    Toyota Tundra Service Manual > Sfi System: Camshaft Position "A" Actuator Circuit (Bank 1) (P0010,P0020)
    DESCRIPTION This DTC is designed to detect opens or shorts in the camshaft oil control valve (OCV) circuit. If the OCV's duty-cycle is excessively high or low while the engine is running, the ECM will illuminate the MIL and store the DTC. The VVT (variable valve timing) system adjusts the intake and ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0177