TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly. Click here (b) Connect the driver side junction block assembly connectors. (c) Measure the voltage and resistance according to the value(s) in the table below.
(d) Install the main body ECU (multiplex network body ECU) to the driver side junction block assembly. Click here (e) Measure the voltage and check for pulses according to the value(s) in the table below.
|
Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line ECM Millimeter Wave Radar Sensor Assembly Cruise control operation signal Accelerator pedal idle position signal Accel override operation signal Cruise control speed status signal Approach warning signal Brake signal Cruise control main ...