Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

3. INSTALL REAR DOOR LOCK ASSEMBLY LH

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

6. INSTALL REAR DOOR GLASS RUN LH

7. INSTALL REAR DOOR SERVICE HOLE COVER LH

8. INSTALL REAR NO. 2 DOOR TRIM BRACKET

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

10. INSTALL REAR DOOR ARMREST COVER LH

11. INSTALL REAR DOOR FRAME GARNISH LH

12. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

13. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Inspection

    Removal

    See More:

    Toyota Tundra Service Manual > Rear View Monitor System(for Navigation Receiver Type): Open or Short Circuit in Back Camera Signal (C1622)
    DESCRIPTION This DTC is stored if the navigation receiver assembly judges as a result of its self check that the signals or signal lines between the navigation receiver assembly and the television camera assembly are not normal. DTC Code DTC Detection Condition Trouble Area C1622 Open or Short Circu ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0357