Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Switch free (Key removed)

10 kΩ or higher

Switch pushed (Key set)

Below 1 Ω

If the result is not as specified, replace the unlock warning switch assembly.

Text in Illustration

*a

Component without harness connected

(Unlock Warning Switch Assembly)

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Propeller Shaft Assembly(for 2wd): Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same installation procedure for both the sleeve yoke side and flange yoke side universal joint spider bearings. (a) Apply MP grease to a new spider and 4 new bearings. NOTICE: Be careful not to apply too muc ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.023