Toyota Tundra Service Manual: Disc cannot be Ejected

Toyota Tundra Service Manual / Audio, Visual, Telematics / Audio / Video / Audio And Visual System / Disc cannot be Ejected

PROCEDURE

1.

PRESS "EJECT" AND CHECK OPERATION

(a) Press the disc eject switch of the radio and display receiver assembly for 2 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
B

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

C

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

A

2.

REPLACE DISC WITH ANOTHER AND RECHECK

(a) Replace the disc with a known good one and check that the malfunction disappears.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
A

END (DISC IS DEFECTIVE)
B

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

C

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

    Diagnostic Trouble Code Chart

    Disc cannot be Inserted or is Ejected Right After Insertion

    See More:

    Toyota Tundra Service Manual > Front Brake: Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake caliper. HINT: Tape the screwdriv ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0295