Components COMPONENTS ILLUSTRATION
Installation INSTALLATION PROCEDURE 1. INSTALL TRANSPONDER KEY ECU
2. INSTALL AIR CONDITIONING UNIT (See page 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 4. REGISTER ENGINE IMMOBILISER SYSTEM (See page 5. CHECK SRS WARNING LIGHT (See page Removal REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the battery terminal. Therefore, make sure to read the disconnecting
the cable from the battery terminal notice before proceeding with work (See page
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 3. REMOVE AIR CONDITIONING UNIT (See page 4. REMOVE TRANSPONDER KEY ECU
|
Toyota Tundra Service Manual > Sfi System: Camshaft Position "B" Actuator Circuit / Open (Bank 1) (P0013,P0023)
DESCRIPTION This DTC is designed to detect opens or shorts in the camshaft oil control valve (OCV) circuit. If the OCV's duty-cycle is excessively high or low while the engine is running, the ECM will illuminate the MIL and store the DTC. The VVT (variable valve timing) system adjusts the intake and ...