Toyota Tundra Service Manual: Transponder Key Amplifier

Toyota Tundra Service Manual / Vehicle Interior / Engine Immobiliser / Transponder Key Amplifier

Components

COMPONENTS

ILLUSTRATION

*A

for Column Shift Type

-

-

*1

LOWER STEERING COLUMN COVER

*2

TRANSPONDER KEY COIL

ILLUSTRATION

*A

for Floor Shift Type

-

-

*1

LOWER STEERING COLUMN COVER

*2

TRANSPONDER KEY COIL

Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSPONDER KEY COIL

(a) Align the transponder key coil with the installation position of the upper bracket with the amplifier inclined.

(b) Push the transponder key coil and install it to the upper bracket.

NOTICE:

Do not push the transponder key coil upward with excessive force.

(c) Connect each connector.

2. INSTALL LOWER STEERING COLUMN COVER

(a) Attach the 2 claws to install the lower steering column cover.

(b) Install the 2 screws.

Removal

REMOVAL

PROCEDURE

1. REMOVE LOWER STEERING COLUMN COVER

(a) While turning the steering wheel to the right and left, remove the 2 screws.

(b) Detach the 2 claws and remove the lower steering column cover.

2. REMOVE TRANSPONDER KEY COIL

(a) Disconnect each connector.

(b) Using a screwdriver, widen the claws attached to the upper bracket by approximately 1 mm (0.0394 in.).

(c) Pull out the transponder key coil with the claws open.

NOTICE:

Take care not to apply excessive force to prevent the case from being damaged.

    Terminals Of Ecu

    Transponder Key Ecu

    See More:

    Toyota Tundra Service Manual > Condenser: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the fins of the cooler condenser are dirty, clean them with water. Dry the fins with compressed air. NOTICE: Do not damage the fins of the condenser. (b) If a fin of the cooler condenser is bent, straighten it using a screwd ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0101