REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER UPPER COVER LH (a) Install the rear bumper upper cover LH with the 2 nuts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf} 2. INSTALL REAR BUMPER UPPER COVER RH HINT: Use the same procedure described for the LH side. 3. INSTALL REAR BUMPER BAR LH (a) Install the rear bumper bar LH with the 5 bolts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf} 4. INSTALL REAR BUMPER BAR RH HINT: Use the same procedure described for the LH side. 5. INSTALL REAR BUMPER PLATE (a) Install the rear bumper plate with the 2 bolts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf} 6. INSTALL NO. 2 FRAME WIRE (a) w/ Towing Package: (1) Attach all the clamps to install the No. 2 frame wire to the receiver hitch bracket sub-assembly. (b) w/o Towing Package: (1) Attach all the clamps to install the No. 2 frame wire to the rear bumper reinforcement sub-assembly. 7. INSTALL NO. 3 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
8. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)
9. INSTALL NO. 2 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
10. INSTALL REAR BUMPER BAR CORNER REINFORCEMENT LH (a) Install the rear bumper bar corner reinforcement LH with the 5 bolts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf} 11. INSTALL REAR BUMPER BAR CORNER REINFORCEMENT RH HINT: Use the same procedure described for the LH side. 12. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
13. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH HINT: Use the same procedure described for the LH side. 14. INSTALL REAR BUMPER PAD SUB-ASSEMBLY LH (a) Attach the 12 claws and 2 guides to install a new rear bumper pad sub-assembly LH. (b) Install the 3 clips. 15. INSTALL REAR BUMPER PLATE LH (a) Attach the 3 claws and clip to install a new rear bumper plate LH. 16. INSTALL REAR BUMPER PLATE RH HINT: Use the same procedure described for the LH side. |
Toyota Tundra Service Manual > Sfi System: Fail-safe Chart
FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily. DTC Component Fail-Safe Operation Fail-Safe Deactivation Condition P0011, P0021, P0015 and P0025 VVT system Idle up (Control of combustion worsening) Stopping fuel-cu ...