Toyota Tundra Service Manual: Rear Door Belt Moulding(for Double Cab)

Toyota Tundra Service Manual / Vehicle Interior / Exterior / Rear Door Belt Moulding(for Double Cab)

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. INSTALL REAR OUTER DOOR GLASS WEATHERSTRIP LH

(a) Attach the claw to install the weatherstrip.

2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL REAR DOOR ARMREST COVER LH

4. INSTALL REAR DOOR FRAME GARNISH LH

5. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

3. REMOVE REAR DOOR FRAME GARNISH LH

4. REMOVE REAR DOOR ARMREST COVER LH

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP LH

(a) Put protective tape around the weatherstrip outer.

(b) Using a moulding remover, detach the claw and remove the weatherstrip.

    Rear Door Belt Moulding(for Crewmax)

    Roof Drip Side Finish Moulding

    See More:

    Toyota Tundra Service Manual > Occupant Classification System: Front Occupant Classification Sensor LH Collision Detection (B1785)
    DESCRIPTION DTC B1785 is set when the occupant classification ECU receives a collision detection signal, which is sent by the front occupant detection sensor LH when an accident occurs. DTC B1785 is also set when the front seat frame with adjuster RH is subjected to a strong impact, even if an actua ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0336