Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• When removing the moulding, heat the vehicle body and moulding using a heat light.
• When replacing a clip, heat the vehicle body and clip using a heat light.

Standard heating temperature:

NOTICE:

Do not heat the vehicle body, moulding and clip excessively.

PROCEDURE

1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH

(a) Put protective tape around the moulding.

(b) Using a heat light, heat the moulding.

NOTICE:

Do not heat the moulding and vehicle body excessively.

(c) Using a moulding remover, detach the clip and remove the moulding.

NOTICE:

• Do not remove the clip from the vehicle body.
• If the clip is damaged or removed accidentally, replace it.

2. REMOVE ROOF DRIP SIDE FINISH MOULDING LH

(a) Put protective tape around the moulding.

(b) Using a moulding remover, detach the clip and remove the moulding.

NOTICE:

• Do not remove the clip from the vehicle body.
• If the clip is damaged or removed accidentally, replace it.

*A	for Double Cab	*B	for CrewMax
	Protective Tape	-	-

3. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP

HINT:

Perform the following procedure only if the clips are damaged or have come off the vehicle.

(a) Remove the 2 roof drip side finish moulding clips.