Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Vehicle Interior / Lighting / Headlight Assembly(for Led Headlight) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY LH

(a) Connect each connector and attach each clamp.

(b) Attach the guide to set the headlight assembly LH.

(c) Install the bolt and 2 screws.

2. INSTALL FRONT END PANEL LH

3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

4. ADJUST HEADLIGHT AIMING

(See page )

    Inspection

    Reassembly

    See More:

    Toyota Tundra Service Manual > Tire Pressure Warning System: Initialization
    INITIALIZATION NOTICE: Initialization can be confirmed through the tire pressure warning light. If the ignition switch is turned off during initialization, the tire pressure warning ECU and receiver memorizes that initialization was being performed. Therefore, it is not necessary to perform the init ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0315