REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER (a) for Manual Tilt: Click here (b) for Manual Tilt and Manual Telescopic Steering Column: Click here (c) for Power Tilt and Power Telescopic Steering Column: Click here 2. REMOVE UPPER STEERING COLUMN COVER (a) for Manual Tilt: Click here (b) for Manual Tilt and Manual Telescopic Steering Column: Click here (c) for Power Tilt and Power Telescopic Steering Column: Click here 3. REMOVE TRANSPONDER KEY AMPLIFIER (IGNITION KEY CYLINDER LIGHT) 
(a) Disconnect the unlock warning switch connector. (b) Detach the 2 claws. (c) Disconnect the connector and remove the transponder key amplifier (ignition key cylinder light). |
Toyota Tundra Service Manual > Rear Leaf Spring: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (see page ). PROCEDURE 1. INSTALL REAR SPRING SHACKLE BUSH (a) Install the 2 shac ...
