Toyota Tundra Service Manual: Communication with BODY ECU (Receive) (U0142)

Toyota Tundra Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Communication with BODY ECU (Receive) (U0142)

DESCRIPTION

The combination meter assembly communicates with the main body ECU (multiplex network body ECU) via the CAN line.

DTC Code

DTC Detection Condition

Trouble Area

U0142

When either of following conditions is detected:

IG voltage 10.5 V or more
No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more

CAN communication system

WIRING DIAGRAM

PROCEDURE

CHECK DTC

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

Result	Proceed to
DTC U0142 is not output	A
DTC U0142 is output	B

HINT:

If the CAN communication system DTC U0142 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0142 first.

USE SIMULATION METHOD TO CHECK

GO TO CAN COMMUNICATION SYSTEM

Lost Communication with Brake System Control Module (U0129)

Lost Communication with Restraints Control Module (U0151)

See More:

Toyota Tundra Owners Manual > Steps to take in an emergency: If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle's battery is discharged. You can also call your Toyota dealer or a qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your vehicle by following ...