Toyota Tundra Service Manual: Outer Rear View Mirror Glass

Toyota Tundra Service Manual / Vehicle Interior / Mirror / Outer Rear View Mirror Glass

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

(a) w/ Mirror Heater:

Connect the 2 connectors.

(b) w/ Retract Mirror:

Connect the 3 connectors.

(c) w/ Blind Spot Monitor:

Connect the 3 connectors.

(d) Attach the 4 claws to install the outer rear view mirror sub-assembly LH.

NOTICE:

Push the mirror downward until a "snap" sound is heard.

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH

(a) Push the upper part of the mirror surface and tilt it.

(b) Using moulding remover D, push the bottom of the outer rear view mirror sub-assembly LH upwards as shown in the illustration. Slide the outer rear view mirror sub-assembly LH upwards to detach the 4 claws, and then remove the outer rear view mirror sub-assembly LH.

Text in Illustration

*1

Moulding Remover D

*2

Protective Tape

HINT:

Apply protective tape to the outer rear view mirror assembly LH to prevent it from being damaged.

(c) w/ Mirror Heater:

Disconnect the 2 connectors and remove the outer rear view mirror sub-assembly LH.

(d) w/ Retract Mirror:

Disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.

(e) w/ Blind Spot Monitor:

Using a screwdriver, disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.

Text in Illustration

*1

Protective Tape
    Removal

    Outer Rear View Mirror

    See More:

    Toyota Tundra Service Manual > Sfi System: Starter Relay Circuit High (P0617)
    DESCRIPTION While the engine is being cranked, the positive battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0096