Toyota Tundra Service Manual: Front Radar Sensor (C1A10)

Toyota Tundra Service Manual / Vehicle Interior / Pre-collision / Pre-collision System / Front Radar Sensor (C1A10)

DESCRIPTION

When an internal malfunction is detected in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1A10	Front Radar Sensor	When the ignition switch is ON, the millimeter wave radar sensor assembly detects an internal malfunction for approximately 1 second or more.	Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.
Click here

PROCEDURE

1.	REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here

(b) Adjust the millimeter wave radar sensor assembly.

Click here

2.	CLEAR DTC (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

END

Stop Light Relay Circuit (C1A4B)

Front Radar Sensor Incorrect Axial Gap (C1A11)

See More:

Toyota Tundra Service Manual > Front Lower Suspension Arm: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT NO. 1 SPRING BUMPER LH (a) Install the No. 1 spring bumper to the vehicle. Torque: 31 N·m {316 kgf·cm, 23 ft·lbf} 2. INSTALL FRONT NO. 2 LOWER ARM LH (a) Using SST and a press, press in a new bush. SST: 09710-26011 09710-05081 NOTICE: Press the bush while mak ...

Toyota Tundra Service Manual: Front Radar Sensor (C1A10)

Stop Light Relay Circuit (C1A4B)

Front Radar Sensor Incorrect Axial Gap (C1A11)

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual