Toyota Tundra Service Manual: Front Camera Module Beam Axis Not Adjusted (C1AA9)

Toyota Tundra Service Manual / Vehicle Interior / Pre-collision / Pre-collision System / Front Camera Module Beam Axis Not Adjusted (C1AA9)

DESCRIPTION

If forward recognition camera adjustment has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, DTC C1AA9 will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AA9

Front Camera Module Beam Axis Not Adjusted

The millimeter wave radar sensor assembly detects that forward recognition camera adjustment has not been completed for 1 second or more.

Forward recognition camera system

PROCEDURE

1.

GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AA9 is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

NEXT

END
    Front Camera Module Incorrect Axial Gap (C1AA8)

    Heater Circuit (C1AAE)

    See More:

    Toyota Tundra Service Manual > Oil Pump: Disassembly
    DISASSEMBLY PROCEDURE 1. FIX OIL PUMP ASSEMBLY (a) Place the oil pump body on the torque converter clutch. 2. REMOVE CLUTCH DRUM OIL SEAL RING (a) Remove the 3 oil seal rings. 3. REMOVE STATOR SHAFT ASSEMBLY (a) Remove the 14 bolts, and then remove the stator shaft from the oil pump body. 4. REMOVE ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0285