DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes. (e) Check for DTCs. Click here CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Pre-Collision 2 / Clear DTCs. (e) Clear the DTCs. Click here |
Toyota Tundra Service Manual > High Beam Main Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition If the result is not as specified, replace the auto high beam switch. 6 ...
