Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY

(a) Check the ELR.

(1) When the inclination of the retractor is 15° or less from its installed position, check that the belt can be pulled from the retractor. When the inclination of the retractor is more than 45° from its installed position, check that the belt locks.

If the operation is not as specified, replace the rear center seat outer belt assembly.

Text in Illustration

*a

Unlocked

*b

Locked

*c

45°

(b) Check the fastening function of the child restraint system.

NOTICE:

The check should be performed with the outer belt installed.

(1) When the belt is pulled out fully, the belt should automatically start to retract.

(2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again.

If the operation is not as specified, replace the rear center seat outer belt assembly.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Cruise Control System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *2 PARK/NEUTRAL POSITION SWITCH ASSEMBLY *3 THROTTLE BODY WITH MOTOR ASSEMBLY *4 ECM *5 FRONT SPEED SENSOR RH *6 FRONT SPEED SENSOR LH *7 REAR SPEED SENSOR RH *8 REAR SPEED SENSOR LH *9 ENGINE ROOM RELAY BLOCK ASSEMBLY, JUNCTI ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0109