Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SEAT OUTER BELT ASSEMBLY

(a) Check the ELR.

(1) When the inclination of the retractor is 15° or less from its installed position, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45° from its installed position, check that the belt locks.

If the operation is not as specified, replace the seat belt assembly.

(b) Check the fastening function of the child restraint system.

NOTICE:

The check should be performed with the outer belt installed.

(1) When the belt is pulled out fully, the belt should automatically start to retract.

(2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again.

If the operation is not as specified, replace the belt assembly.

    Rear Seat Outer Belt Assembly(for Double Cab)

    Installation

    See More:

    Toyota Tundra Service Manual > Navigation System: Panel Switches do not Function
    PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter on the display. OK: The display is clean. NG REMOVE ANY FOREIGN MATTER FOUND OK 2. CHECK PANEL SWITCH (OPERATION CHECK) (a) Enter the "Panel & Steering Switch Check Mode" screen. [Refer to Check Panel & Steering Switch in Operation ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2023 Copyright www.ttundra.com
    0.0096