Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. INSTALL REAR SEAT OUTER BELT ASSEMBLY

(a) Align the vehicle's claws with the seat belt retractor positioning holes.

(b) Install the seat belt with the 2 bolts.

HINT:

First install bolt A, and then install bolt B.

Torque:

for bolt A :

12.5 N·m {127 kgf·cm, 9 ft·lbf}

for bolt B :

42 N·m {428 kgf·cm, 31 ft·lbf}

(c) Install the shoulder anchor with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY

3. INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY

(a) Attach the 6 clips to install the quarter trim panel lower.

(b) Install the seat belt anchor with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

(c) Attach the 2 claws to install the cover.

4. INSTALL REAR DOOR SCUFF PLATE

5. INSTALL REAR SEAT ASSEMBLY

(a) Install the rear seat (see page ).

    Inspection

    Removal

    See More:

    Toyota Tundra Service Manual > Differential: Front Differential Side Gear Shaft Oil Seal(for 4wd)
    ComponentsCOMPONENTS ILLUSTRATION ReplacementREPLACEMENT CAUTION / NOTICE / HINT HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified. PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (a) R ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0305