Toyota Tundra Service Manual: Customize Parameters

Toyota Tundra Service Manual / Vehicle Interior / Seat Belt / Seat Belt Warning System / Customize Parameters

CUSTOMIZE PARAMETERS

PROCEDURE

1. CUSTOMIZE SEAT BELT WARNING SYSTEM

HINT:

The following items can be customized.

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.
  • These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).

(a) Customizing with the Techstream

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Warning.

(5) Select the setting by referring to the table below.

Warning

Display

Default

Content

Setting

Relevant ECU

Driver Side Seatbelt Warning Buzzer

ON

Function to sound the driver seat belt warning buzzer

ON/OFF

Combination meter assembly

Front Passenger Side Seatbelt Warning Buzzer

ON

Function to sound the front passenger seat belt warning buzzer

ON/OFF

HINT:

This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.

    Seat Belt Warning System

    Data List / Active Test

    See More:

    Toyota Tundra Service Manual > Front Differential Carrier Assembly(for 4wd): Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL STRAIGHT PIN (a) Using a plastic-faced hammer, tap in the straight pins until their protrusion amounts are at the specified values shown in the illustration below. Standard depth: Item a b c for Straight Pin A 19.5 to 20.5 mm (0.768 to 0.807 in.) 9.991 to 10.000 mm (0 ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0129