INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (CLIMATE CONTROL SEAT SWITCH) (a) Attach the 3 clips to connect the air conditioning control assembly (climate control seat switch) to the center lower instrument panel finish panel. (b) Connect each connector. (c) Attach the 8 clips, 2 claws and guide to install the air conditioning control assembly (climate control seat switch) together with the center lower instrument panel finish panel. 2. INSTALL FRONT CONSOLE BOX
3. REMOVE REAR CONSOLE BOX ASSEMBLY
4. REMOVE CONSOLE BOX CARPET
5. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
Toyota Tundra Service Manual > Steering Pad: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STEERING PAD (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). (b) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new on ...
