INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (SEAT HEATER SWITCH) (a) Attach the 3 clips to connect the air conditioning control assembly (seat heater switch) to the center lower instrument panel finish panel. (b) Connect each connector. (c) Attach the 8 clips, 2 claws and guide to install the air conditioning control assembly (seat heater switch) together with the center lower instrument panel finish panel. 2. INSTALL FRONT CONSOLE BOX
3. REMOVE REAR CONSOLE BOX ASSEMBLY
4. REMOVE CONSOLE BOX CARPET
5. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
Toyota Tundra Service Manual > Front Seat Side Airbag Assembly(for Power Seat): On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). (b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, repl ...
