Toyota Tundra Service Manual: Sliding Roof Switch Assembly(for Crewmax)

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT SLIDE ROOF MOTOR SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
1 (UP) - 5 (E)	Tilt switch is pressed to up	Below 1 Ω
1 (UP) - 5 (E)	Tilt switch is not pressed to up	10 kΩ or higher
2 (DOWN) - 5 (E)	Tilt switch is pressed to down	Below 1 Ω
2 (DOWN) - 5 (E)	Tilt switch is not pressed to down	10 kΩ or higher
4 (OPN) - 5 (E)	Slide switch is pressed to open	Below 1 Ω
4 (OPN) - 5 (E)	Slide switch is not pressed to open	10 kΩ or higher
3 (CLS) - 5 (E)	Slide switch is pressed to close	Below 1 Ω
3 (CLS) - 5 (E)	Slide switch is not pressed to close	10 kΩ or higher

If the result is not as specified, replace the slide roof motor switch.

Text in Illustration

*1	Tilt Switch
*2	Slide Switch
*a	Up
*b	Down
*c	Open
*d	Close
*e	Component without harness connected (Slide Roof Motor Switch)

Installation

INSTALLATION

PROCEDURE

1. INSTALL SLIDE ROOF MOTOR SWITCH

(a) Attach the 4 claws to install the slide roof motor switch.

(b) Connect the connector.

Removal

REMOVAL

PROCEDURE

1. REMOVE SLIDE ROOF MOTOR SWITCH

(a) Put protective tape around the roof console box base.

Text in Illustration

*1	Protective Tape

(b) Using a screwdriver, detach the 8 claws.

HINT:

Tape the screwdriver tip before use.

(d) Detach the 4 claws and remove the slide roof motor switch.

Toyota Tundra Service Manual > Air Conditioning System(for Manual Air Conditioning System): Compressor Lock Sensor Circuit (B1422/22)
DESCRIPTION The ECM sends an engine speed signal to the air conditioning amplifier via the CAN communication system. The air conditioning amplifier reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier determines that th ...

Toyota Tundra Owners Manual