Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (see page ).

2. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (see page ).

3. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

(a) Replace the center airbag sensor.

CAUTION:

For removal and installation procedures of the center airbag sensor, be sure to follow the correct procedure.

HINT:

The center airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to the impact.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Fog Light Assembly(for Halogen Fog Light): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT ASSEMBLY LH (a) Attach the 2 guides to install the fog light assembly LH. (b) Install the screw. 2. INSTALL FRONT BUMPER ASSEMBLY ( ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0233